Talk:TI-68

This article is rated Stub-class on Wikipedia's content assessment scale.
It is of interest to the following WikiProjects:

Computing

	This article is within the scope of WikiProject Computing, a collaborative effort to improve the coverage of computers, computing, and information technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.ComputingWikipedia:WikiProject ComputingTemplate:WikiProject ComputingComputing articles
???	This article has not yet received a rating on the project's importance scale.
	This article has been automatically rated by a bot or other tool as Stub-class because it uses a stub template. Please ensure the assessment is correct before removing the `\|auto=` parameter.

Bad production quality[edit]

The Ti-68 was made with ribbon cables connecting the print and the LCD display. Those cables were glued to the conducting pads on the display and the printed circuit board. The conductive glue tends to deteriorate and lift off single conductors leading to display pixel failures. You may try to re-glue the ribbon using a soldering iron at about 150 centigrade, but there is no long life expectance to be promised. Sorry to say, the Ti-68 is one of the worst Texas Instruments products ever. 193.83.191.242 (talk) 16:51, 18 December 2017 (UTC)wabi193.83.191.242 (talk) 16:51, 18 December 2017 (UTC)[reply]