M1879 Reichsrevolver

Reichsrevolver Model M79
M1879 German Trooper's Revolver
Type	Revolver
Place of origin	German Empire
Service history
In service	1879 – 1945
Used by	German Empire
Wars	German colonial conflicts, Boer Wars, Boxer Rebellion, World War I
Production history
Manufacturer	V.C. Schilling & Cie Spangenberg & Sauer C.G. Haenel Mauser Königliche Gewehrfabrik Erfurt
No. built	about 450,000 (M1879 and M1883 combined)
Variants	M1883 (5 in barrel)
Specifications
Mass	1.3 kg (2.9 lb) (M1879) 0.9 kg (2.0 lb) (M1883)
Length	345 mm (13.6 in) (M1879) 225 mm (8.9 in) (M1883)
Barrel length	181 mm (7.1 in) (M1879) 117 mm (4.6 in) (M1883)
Cartridge	10.6×25mmR
Caliber	10.6 mm (.41 in)
Action	Single action
Muzzle velocity	670 ft/s (200 m/s)
Feed system	6-round cylinder

The M1879 Reichsrevolver, or Reichs-Commissions-Revolver Modell 1879 and 1883, were service revolvers used by the German Army from 1879 to 1908, when it was superseded by the Luger.

The two versions of the revolver differ in barrel length (The M1883 had a 5-inch barrel) and grip shape. Although the design was dated, the weapon was extremely robust, and they were still used through World War I and until 1945 by the security of the customs administration. The M1879 is referred to as the "cavalry model" and the M1883 as the "officer's model," by collectors, which were not official designations.

Design

Both models were single-action, solid frame, non-ejecting six-shot revolvers. The caliber was an indigenous 10.6×25mmR with a medium-length cartridge case, comparable to the contemporary .44 Russian round in size and power. Loading was via a gate on the revolver's right side, and the cylinder was released by pulling the hammer to half-cock. Removing empty cartridges could be done by removing the cylinder by withdrawing the axis pin, and then removing the casings by hand, but in actual practice a separate small rod (stored in the ammunition pouch) was used to push the casings out without having to remove the cylinder. A unique feature among these revolvers was the safety lever, which was often applied with the hammer resting in the half-cock position.

Most revolvers came with a lanyard ring for attachment to the uniform.

See also

• Mauser Zig-Zag

References

• Military Small Arms of the Twentieth Century, 7th Edition, Weeks, John, Hogg, Ian V.